Can use squirrel cage asynchronous motors: This type of small motor, conveyor mechanical variable speed drive can be similar to the aerospace department's speed, drive can be small, lightweight form; If the gears are reconnected, it will achieve twice the result with half the effort. Without brushes or commutators, it is almost maintenance free.

It can only be set in these two circuit designs, and the motor can be inserted into the gear for speed transmission, converting it into infinite variable speed.

In order to improve performance, gear transmission is used at a ratio of 1:10 to 1:20, with a wide range of speed control and soft start stop adjustment. The set time is smooth and soft to change the speed, ensuring the safety and quality of the entire product.

Often able to play a role,:

The low frequency and voltage range of gears are numbered to slowly increase the frequency and voltage values, thus directly increasing the current generated by small and large starting torques with good starting efficiency compared to commercial forces. The result of a small heat generating motor is that it has more frequent starts, stops, and is harmless

The forward or reverse gear control of the bay is the phase rotation from the transistor switch. This method means that compared to the previous stage where the main circuit wires pass through the switch, the heat generated by the movable parts and friction will be more efficient. Therefore, you can return to the horizontal (transverse) direction for frequent forward and reverse transportation, allowing remote commands to change the frequency in this way. So, it is easy to choose the appropriate work speed that needs to be used appropriately.

When electric braking decelerates, the supply of the motor will slowly decrease, and the output frequency and motor speed will exceed the synchronous speed. When no resistor is used in this state, the motor still has an internal loss of 20% of the braking force. Usually, conveyors have a constant torque load, so they quickly decelerate unless necessary, as there are no occasions where braking resistors need to be set. Low frequency braking, especially if using vector control low-speed mode, can achieve a speed control range of 1:100 to 1:1000'S as an alternative speed control operation compared to PG speed control.

Obedient start and stop: Due to the fast speed and conveying speed, the material will collapse when sent, for example, if the glass suddenly stops moving, it may damage the moving bottle and glass bottle; However, if the operation of the gear starts at a low frequency, there will be small vibrations, which are then controlled by softness.